Imagitarium (petco) 3.7 gallon kit review. - Tropical Fish Keeping - Aquarium fish care and resources
  • 3 Post By
LinkBack Thread Tools
post #1 of 1 Old 01-23-2016, 06:41 PM Thread Starter
New Member
Imagitarium (petco) 3.7 gallon kit review.

Hey fish friends! I'm new to the forum and getting back into fish keeping after many years hiatus. I wanted to post a review of the tank I just purchased at petco. Its the Imagitarium (which is the new name for the petco brand) 3.7 gallon cube aquarium. At $50 it is an all glass square aquarium with a 3 stage internal filter. Along with the tank you get a floss/carbon filter cartridge, a bio media filter cartridge, a corse foam filter insert, an aqua one submersible pump to drive the filter, a full glass cover, and a LED clip on back light.

The tank:
Beautifully designed the two front corners are rounded for a classy look. It is mounted on a small block in the center of the tank bottom to make the tank look elevated. The tank was well sealed and no leaks appeared.

The filter:
The submersible aqua one provides an adjustable flow rate pull through the filter. Since I am keeping a Betta I had adjusted the flow rate to its minimum which was still too strong for the species. After placing a block of foam over the outflow nozzle the rate flowed to a comfortable trickle. Not sure what the gph is because I cannot read the label from inside the pump compartment.
The filtration section is a typical slotted in-tank cartridge design that seems to work well. The order of the cartridges given in the instructions from intake to outflow is carbon, bio, and foam after which water is returned via the pump. I will be replacing the carbon cartridge with a mechanical media once the tanning from the driftwood is eliminated.

The hood:
Its all glass and follows the shape of the tank which is rounded corners up front and 90 deg angles in the back corners. Its covers the entire surface except an 1/8 in around the perimeter and a half circle hole up front as a lift point.

The light:
The light clips on the back edge of the aquarium with two screws that clamp against the aquarium glass. This was a little unnerving to me as I could picture the glass breaking if you overtightened them or put too much pressure adjusting the light angle. Its been ok so far but I think the design could have been better.
As far as the light itself there are 3 settings. One is an all blue "night" setting, a mix of white and blue, and an all white light setting. I'm not the most experienced aquarist when it comes to good or bad lighting but it seems to do a decent job to me. I keep the light off most of the time anyhow and rely on ambient room lighting as betta are a low light fish.

The kit does not include a heater although I purchased a Cobalt Easy Therm 25w that fits perfectly opposite the pump in the pump chamber and does a perfect job. Tank is a constant 80F. With some sand, plants, driftwood, and a Betta, this turned out to be a great little slice of the asian freshwater tropics! Definitely a decent setup that I would recommend to any small tank fanatic.
Attached Images
File Type: jpg IMG_0922.jpg (24.6 KB, 41 views)
File Type: jpg IMG_0925.jpg (49.1 KB, 34 views)
File Type: jpg IMG_0913.jpg (60.5 KB, 32 views)
mbprop79 is offline  

3.7 gallon , betta tank , imagitarium , petco tank

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page

Similar Threads
Thread Thread Starter Forum Replies Last Post
Solarmax HE T5 Dual Daylight 224 REVIEW REVIEW Video DjBootleg Freshwater Journals 1 03-25-2013 03:23 PM
Review for Aqueon 16 Gallon Deluxe Bow Front Aquarium Kit, please. La Reina Aquarium Products Reviews 1 12-06-2009 02:05 PM

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome