Ph and CO2
I have made the transition from years of plastic plants in my freshwater tank to a fully planted tank. I have also stopped using carbon, Phoszorb and Nitrazorb filters, going instead with just foam sponges and Biomax. I have a Fluval canister filter system with an inline heater (I keep the temp 72-74 F). I have no more algae problems. My plants seem to do OK and grow slowly. I trim the brown leaves and stems that develop. Java moss is doing well. I have 4 clown loaches, 5 cardinal tetras, 4 red eye tetras and 3 yellow fin tetras and 3 other tetras that look copper on their fins. All fish do well.
My tank is 40 gallons. I do 50% water changes every week. I add Fluorish every 3 days.
As section of my tank has a floating plant to provide some partial shade (the tetras love hiding out in it).
My tank runs consistent parameters when I test the day I do a water change:
pH 6.0 - 6.2
I vacuum the gravel once a month.
I have read that plants like a pH higher than my tank's pH. Is this true?
Also, I don't measure the CO2 in my tank. Should I be doing so? If so, then is it best to do so during the day or at night? I have the tank's light running ~10 hours on average each day.
plants will be fine at that pH generally. If you ever reach very dense fast growth you may just find that you need magnesium and calcium addition for the plants.
As far as CO2 you don't need to monitor it unless you are adding it. On a tank that size only a pressurized system will need to be monitored.
Thanks for the info!
Does it matter how fast I set the filtration? Does that affect the CO2 level at all?
Not so much how fast it is but how much it disrupts the surface of the water. The more surface agitation there is, the more gas exchange there it.
Measuring CO2, if you are running pressurized, get a drop checker. That will give you a guide as to how much CO2 is dissolved in the water. As long as the color is in the green, you are good. Start dipping down into the more yellowish color, it could be too much. Not for the plants but for the fish.
Thanks again. I have not been adding any CO2 to my tank. I can get a CO2 test kit and check the status of the CO2 level.
Opps...for some reason I thought I read you were adding CO2. If not, really no need to test. Plants do like lots of CO2 and without adding it, you are getting a limited amount. If the plants are healthy then there isn't anything to worry about. If you want them to grow faster, add CO2, more light, and ferts. If you are happy with the growth rate, keep it as is.
Agree with what has been posted. One thing to add on the filter question, and that is that water flow can impact CO2 assimilation by plants. So while the flow in the tank will not deplete CO2 (surface disturbance will as was already mentioned), too fast a water current makes it hard for plants to grab the CO2. The increase in oxygen is also detrimental.
This came up in another thread recently; rather than repeat, here's the link, my comments are in post #4:
Thanks for giving the very useful information. I really liked it.
|All times are GMT -5. The time now is 11:05 AM.|
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.