Guide to setting up a Soil substrate planted tank
Soil Substrates 101
This topic will explain how to set up a soil-substrate aquarium, and the risks/benefits of doing so. I will be updating this as I create one of my 10 gallon aquariums. If you have an empty aquarium, you can do the steps as I do them, over the course of a month or so. http://www.inselpix.com/images/redch...k6xflss500.jpgDiane Walstad is the world's expert on the subject and her book is highly reccomended... For best results, read the book first. (I might have missed something. :) )
Benefits of a Soil Substrate NPT (Natural Planted Tank)
Good plant growth.
No injected CO2 required.
No or little algae.
No need for additional fertilisers. (and less overall cost)
No need for frequent water changes once the tank is established. (Many people change the water every 6 months, some people less often)
Biofilter is not be required (plants will take care of the ammonia, nitrite and nitrate, and the soil bacteria will also consume nitrogen. Water movement is suggested but not required.)
Slightly more flexibility in the lighting intensity.
Organisms in the soil (planaria, etc) will usually thrive (usually hard to spot unless you look for them), and provide food for any fry present.
Risks of a Soil Substrate NPT
Some soils are nutrient rich and can release ammonia or chlorine into the aquarium for a long period of time.
Prevented by: Mineralising topsoil and only using acceptable bagged soils.
The soil layer can become anaerobic, which is a very very bad thing. Anaerobic basically means that the soil isn't oxygenated enough, and the bad bacteria takes over. Bubbles rising from the substrate and a strong sulfur/rotten egg smell is a dead giveaway.
Prevented by: Using 2 inches or less of soil mixture, and 1.5 inches or less of gravel. If using sand, use 1 inch or less. MTS (trumpet snails), Blackworms (Also sold as 'California Blackworms'- actually Lumbriculus variegatus), or poking the substrate frequently the first few weeks can also help prevent anaerobic conditions.
It is also important to stock with plants that have extensive root systems- plant roots have the ability to prevent anaerobic conditions.
Some good rooted plants are:
Echinodorus species (Make sure you find species that are proper for your tank)
Vallisneria (For taller aquariums)
Even safe soils can leach ammonia into the water faster than the plants can assimilate it, causing algae outbreaks or toxic ammonia levels the first weeks or months.
Prevented by: Initially stocking the aquarium with fast-growing plants, floating plants (Water lettuce, frogbit, some stem plants left floating) to use nutrients. Also make sure you have sufficient light.
Good fast growing plants should be used when you start up the aquarium. Slower-growing plants can be added later.
Stem plants in these families are all fast growing- Rotala sp. Ludwigea sp. Egeria sp. Hygrophila sp.- along with rooted plants listed above. 'Mineralising' the soil also will eliminate raw organics and give them a chance to break down before you set the aquarium up.
Many of these risks can also be prevented by using the Dry Start Method, but that's an entirely different process which I've never tried. The basic concept is to set up the aquarium as a terrarium, with 'bog plants'. The plants will grow much faster in their emersed state, and when the aquarium has grown in you fill it up with water. If there is interest, I may set up one of my 10s using that process and record it in a different topic.
I use a combination of 'mineralised' garden soil (dug out of my yard) and "miracle grow organic choice" potting soil. If you are wary of using soil from your yard, you can buy cheap "top soil" from a home improvement store.
As I said, I will be posting these steps as I do them, and try to take photos regularly to show the growth (along with any pitfalls) that it experiances. It will be a South American regional biotope stocked with livebearers. (Yes, I'm converting my 10G livebearer :-D)
STEP ONE: Mineralising the soil
This is straight-forward, so no pictures yet.
I have an area in my back yard that frequently floods, so I will be using soil from that area. The fact that it floods is a dead giveaway that it is rich in clay. Clay is nutrient-rich, but has an extremely high CEC (Cation exchange capacity) which basically means it releases it's nutrients very slowly, and directly to the plant's roots. You can use any soil that is free from chemical fertilisers, pesticides, etc.
Since I use a 1:2 mixture of mineralised soil and "Organic Choice potting soil", you don't need much topsoil. I only use about a cupful for every 5 gallons. No need to measure it now, just "aquire" about a shovel-load for every ten gallons. Any soil left can go back where it came from or stored for later use.
Many people use a tarp and water it with the hose, but I have a wide 4-5 gallon bucket that I use. Break up the soil, and remove any large rocks, roots, grass and organic matter. (If you miss some, that's okay, it will float later if you are using a bucket.)
If you are using a tarp, spread it out to approximately 1 inch thick, and spray it with the hose (just so it is damp, not soggy). If you are using a bucket, I break it up into small pieces and fill the container so the soil is almost covered.
When the soil is dry, wet it again. If you are using a bucket, then stir it so the organic material floats to the top, pour off half the water, refill, and wait.
While this is working, you can make sure your tank is clean and start researching and deciding which plants and fish you will want.
I get bubbles from time to time rising up from the substrate but no smell so far. Is this a sign of futre trouble? Tanks maybe 3 weeks old now, so far it seems to be doing well.
It probably is pockets of anaerobic bacteria, but every tank, no matter the substrate, has a few pockets.
Do you have any mts snails? If not poke the gravel with a stick to release as much as possible.
Do you have a lot of rooted plants?
If you set the soil and gravel layers up dry, it could be just air bubbles.... It's reccomended to wet the soil thoroughly (not to where it is soupy) before placing the gravel on top to prevent that...
Definately poke it. http://www.freesmileys.org/smileys/smiley-fc/poke.gif
I actually have tried to add a few snails from another tank but the Ciclids trounce those suckers as soon as you try to put them in the tank. I did minelalize the soil before adding to tank and it was damp when i put it in. Its about 1.5" think and the rock is about the same. The bubbles are starting to slow a bit but they are still there.
I will give the stick poking a try tomorrow, thanks!
Wow, cichlids that can crush a MTS... Must be some powerful fish.
Try the stick. :)
I was looking at my notes, and it turns out I was way off when I types the 1:2 proportions of topsoil and organic choice... What I actually did two of the times was to layer it, and only use enough of the topsoil just barely cover the organic choice. I did this to provide trace elements that might not be present, provide a barrier with a high CEC, and, more importantly, so 'seed' the (more or less sterile) organic choice with some good 'ole dirty soil bacteria.
Organic choice works well by itself, so feel free to do it that way, but my soil is still mineralising... I'll post pictures when the soils done and I get the sand.
first article was great, second article scares the crap out of me. Im gonna go buy a UV sterilizer now... just in case.
I would advise against it- I don't think it's critical, and I don't think it's worth the cost...
They get rid of infusoria and beneficial things in the water. She mentions that it's probably in the water of most aquariums and the fish's immune system can sometimes fight it off...
Keep healthy happy fish, quarantine, and you'll have no problems.
oh i was gonna keep it on hand so i can set it up if i see illness amongst my fish. I would not keep it in all the time.
|All times are GMT -5. The time now is 10:09 AM.|
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0 PL2