Tropical Fish Keeping banner

Overflow box water level

8K views 10 replies 4 participants last post by  Reefing Madness 
#1 · (Edited)
Where should the water level in an overflow box be? Can we even control that? I am building a no teeth box and figured on putting it just above the trim level so the water surface is not visible. Where would the water level in the box be: at the bottom of the hole, halfway full or would it be above the fitting? For a herbie design what should the height difference be between the top of the back up drain and the bottom of the siphon? I am trying to figure out if the holes should be on the same line or staggered a bit.
I am using 1 inch bulkheads, flexible tubing, and the box will be roughly 7x4x5.
 
#2 ·
You should adjust you running levels in the upper containers and your sump to prevent floods.

On power out the water that drains to the sump should not flood. So you have to adjust the running water level low enough prevent the flood.

In the case of drain blockage you need to adjust both you upper container(s) levels and the sump levels so that the sump runs dry before the upper containers flood.

Not much help but basically you do have to adjust untill things work.

The lower you keep the upper container level, the more water can be pumped from the sump with a drain failure before floods. And the higher the sump water level can be. So there is a tie in between the two. I usually set the upper container at some astetic level say right at the bottom of the top trim line. Then adjust the sump level to prevent floods.

my .02
 
#4 ·
Yes.
That is another thing you check for.

But even with an hob overflow that breaks siphon, you should adjust so that even in that case you don't get a flood. Again, the sump runs out of water before the upper container floods. I test for that by just forcing the siphon break/ drain blackage.

I also use the return pump or a powerhead to suck out any air in a hob design. To help prevent siphon breaks and reestablish siphon should siphon be lost.

I also make overflows from pvc pipes with a water trap design. So the overflow boxes are not necessary. But then ugly pipes are. :lol:

my .02
 
#8 ·
I considered that, the Bean animal overflow, I am waiting for the Reefingmadness overflow that uses 4 lines. Haha. Does anyone know if the water just comes up the elbow, flows over with minimal depth and down to the sump or does it fill the horizontal halfway or all the way? Or am I making an issue out of nothing. Maybe I should just build it and let it fly.
 
#9 ·
Reefing Madness Overflow- To be continued. =)...j/k I use a CPR Overflow box with Aqualifter. I don't have any problems, and I turn it off twice a week for Mysis feedings.
Anyways, the pipes will take the water down, it won't fill the box with water per say. But, here look at this, it will give you a good idea what your looking for as far as water and what nots.
Bean Animal's Or Herbie Over Flow (Version 2) - YouTube
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top